Not sure what you need to complete that Full-Floater Conversion? Can't find the parts, or don’t have time? Front Range Off-Road Fabrication now offers “Floater Chunks”. This kit contains everything needed to convert your axle to a Full Floating rear axle. Floater Chunks are for anyone who needs all the Full Floater conversion components in one convenient package! Available fully assembled or with some assembly required. NOTE: Our Full Float Seal Holder will fit stock and Diamond Axle housings. We cannot guarantee the fit on other aftermarket housings.
The included spindles, hubs and locking hubs are used original parts.
Assembly includes reconditioning used components, painting, installing new bearing races, installing ARP hub stud, pressing wheel studs. Bolting spindles to Full Float Adapter Ring, greasing and setting wheel bearing preload. You will need to install the chunk to the axle with light grease on the axle shaft, some silicone between the adapter ring and the end of the axle housing. Also tighten the Hub Stud nuts, install axle shaft snap ring, and either locking hub dial or drive flange cap.
The Kit Includes:
- Full Floater Conversion Stock version
- 2 Toyota Solid Axle Spindles
- 2 Toyota Wheel Hubs
- 2 Wheel Bearings kits
- 2 Wheel Bearing Nut Kits
- 1 ARP Hub Stud Kit
- 12 Hub Stud Cone Washers
- 12 Flat Washers for Hub Studs
- 12 Wheel Studs
- 2 Brake Rotors
- 2 Loaded rebuilt calipers with pads
- 16 Spindle Bolts
- 4 Caliper Bolts
- 6 Gaskets and 4 seals, including large outer hub dust shield
- 2 Dust Shield Center Plates
- 2 Drive Flanges or Locking Hubs